Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 643
ip address
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 643 highlights
Example • Internet Control Message Protocol* * but not the ICMP message type (0-255) • Any Internet Protocol • Transmission Control Protocol* * but not on the rst, syn, or urg bit • User Datagram Protocol icmp ip tcp udp In the case of ambiguous access control list rules, the debug ip packet access-control command will be disabled. A message appears identifying the error (see Figure 24-4). Figure 24-4. debug ip packet access-group Command Errors FTOS#debug ip packet access-group test %Error: port operator GT not supported in access-list debug %Error: port operator LT not supported in access-list debug %Error: port operator RANGE not supported in access-list debug %Error: port operator NEQ not supported in access-list debug FTOS#00:10:45: %RPM0-P:CP %IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off FTOS# ip address c e s Assign a primary and secondary IP address to the interface. Syntax ip address ip-address mask [secondary] To delete an IP address from an interface, use the no ip address [ip-address] command. Parameters ip-address mask secondary Enter an IP address in dotted decimal format. Enter the mask of the IP address in slash prefix format (for example, /24). (OPTIONAL) Enter the keyword secondary to designate the IP address as the secondary address. Defaults Not configured. Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Usage You must be in the INTERFACE mode before you add an IP address to an interface. Assign an IP Information address to an interface prior to entering the ROUTER OSPF mode. IPv4 Routing | 643