Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1510

www.dell.com | support.dell.com Advanced ASIC Debugging Commands • clear hardware unit • show cpu-interface-stats • show hardware unit • show revision clear hardware unit c Clear debugging information on the internal Gigabit Ethernet interfaces on the CSF and FP ASICs. Syntax clear hardware {linecard number | rpm number} unit number counters Parameters linecard rpm number Enter the keyword linecard to clear information about a line card. Enter the keyword rpm to clear information about an RPM. Enter a number: • After the keyword linecard: • Range: 0-7 for the C3000 • After the keyword rpm: Range: 0-1 • After the unit keyword: For a line card: Range: 0 - 3 For an RPM: Range 0 - 4 Defaults None. Command Mode EXEC EXEC Privilege Command History Usage Information Version 7.5.1.0 Introduction Warning: Use this command only when you are working directly with a technical support representative to troubleshoot a problem. Do not use this command unless a technical support representative instructs you to do so. show cpu-interface-stats c The command provides an immediate snapshot of the health of the internal RPM and line card CPU. Generally this command is used in concert with Dell Force10 Technical Support engineers. Syntax show cpu-interface-stats {cp | lp | rp1 | rp2} Parameters cp lp Enter the keyword cp to display the CP's interface statistics. Enter the keyword lp to display the LP's interface statistics 1510 | C-Series Diagnostics and Debugging