Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 765

neighbor filter-list c e Configure a BGP filter based on the AS-PATH attribute. Syntax neighbor {ipv6-address | peer-group-name} filter-list as-path-name {in | out} To delete a BGP filter, use the no neighbor {ipv6-address | peer-group-name} filter-list as-path-name {in | out} command. Parameters ipv6-address peer-group-name as-path-name in out Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to apply the filter to all routers in the peer group. Enter the name of an established AS-PATH access list. If the AS-PATH access list is not configured, the default is permit (to allow routes). (16 characters maximum) Enter the keyword in to filter inbound BGP routes. Enter the keyword out to filter outbound BGP routes. Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale neighbor maximum-prefix c e Control the number of network prefixes received. Syntax neighbor {ipv6-address | peer-group-name} maximum-prefix maximum [threshold] [warning-only] To return to the default values, use the no neighbor {ipv6-address | peer-group-name} maximum-prefix maximum [threshold] [warning-only] command. Parameters ipv6-address peer-group-name maximum Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group. Enter a number as the maximum number of prefixes allowed for this BGP router. Range: 1 to 4294967295. IPv6 Border Gateway Protocol (IPv6 BGP) | 765