Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 742
bgp dampening, default, local-preference, no bgp default local-preference, bgp enforce-first-as, no
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 742 highlights
www.dell.com | support.dell.com Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage Information If you enter bgp dampening, the default values for half-life, reuse, suppress, and max-suppress-time are applied. The parameters are position-dependent, therefore, if you configure one parameter, you must configure the parameters in the order they appear in the command. Related Commands show ip bgp ipv6 unicast dampened-paths View the BGP paths bgp default local-preference c e Change the default local preference value for routes exchanged between internal BGP peers. Syntax bgp default local-preference value To return to the default value, enter no bgp default local-preference. Parameters value Enter a number to assign to routes as the degree of preference for those routes. When routes are compared, the higher the degree of preference or local preference value, the more the route is preferred. Range: 0 to 4294967295 Default: 100 Defaults 100 Command Modes ROUTER BGP Command History = Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage The bgp default local-preference command setting is applied by all routers within the AS. Information bgp enforce-first-as c e Disable (or enable) enforce-first-as check for updates received from EBGP peers. Syntax bgp enforce-first-as To turn off the default, use the no bgp enforce-first-as command. Defaults Enabled 742 | IPv6 Border Gateway Protocol (IPv6 BGP)