Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 454

www.dell.com | support.dell.com show configuration lock c e Show the configuration lock status. Syntax show configuration lock Defaults None Command Modes EXEC Privilege Command History Example Version 7.7.1.0 Introduced on C-Series and E-Series Figure 14-4. show configuration lock Command Output FTOS# show configuration lock Configure exclusively locked by the following line: Line Line number User Type State Ip address : vty 0 : 2 : admin : AUTO : LOCKED : 10.11.9.97 Usage Information The type may be auto, manual, or rollback. When set to auto, FTOS automatically denies access to CONFIGURATION mode to all other users every time the user on the listed VTY line enters CONFIGURATION mode. When set to manual, the user on the listed VTY line must explicitly set the lock each time before entering CONFIGURATION mode. Rollback indicates that FTOS is in a rollback process. The line number shown in the output can be used to send the messages to that session or release a lock on a VTY line. Related Commands clear line configuration mode exclusive send Reset a terminal line. Enable exclusive configuration mode. Send messages to one or all terminal line users. show run diff c e Display the difference between an archived file and a file. Syntax show run diff {flash: | startup-config} Parameters flash: startup-config Enter the archive configuration file using the path [flash://]filename Enter the keywords startup-config to compare the contents of the startup configuration. Defaults No default values or behavior Command Modes EXEC Privilege Command History Version 7.6.1.0 Introduced on C-Series and E-Series 454 | Configuration Rollback