Dell PowerConnect 5448 User's Guide - Page 27
Physical Dimensions, LED Definitions, Port LEDs - reset switch
View all Dell PowerConnect 5448 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
If both RJ-45 and SFP are present, and a connector is inserted in the SFP port, the SFP port is active, unless the copper connector of the Base-T port of the same number is inserted and has a link. The system can switch from the RJ-45 to the SFP (or vice-versa) without a system reboot or reset. Physical Dimensions The device has the following physical dimensions: • Height - 44 mm (1.73 inch) • Width - 440 mm (17.32 inch) • Depth - 255 mm (10.03 inch) LED Definitions The front panel contains light emitting diodes (LED) that indicate the status of links, power supplies, fans, and system diagnostics. Port LEDs 10/100/1000 Base-T Port LEDs Each 10/100/1000 Base-T port has two LEDs. Speed/link/activity is indicated on the left LED and the duplex mode is indicated on the right LED. Figure 2-4. RJ-45 Copper based 10/100/1000 BaseT LEDs The RJ-45 LED indications are described in the following table: Table 2-1. RJ-45 Copper based 10/100/1000BaseT LED Indications LED Left LED Right LED Color Green Static Green Flashing Orange Static Orange Flashing Green OFF Description The port is linked at 1000 Mbps. The port is transmitting or receiving data at 1000 Mbps. The port is linked at either 10 or 100 Mbps. The port is transmitting or receiving data at either 10 or 100 Mbps. The port is currently transmitting in Full Duplex mode. The port is operating in Half Duplex mode. Hardware Description 27