Dell PowerConnect 5448 User's Guide - Page 302

• GARP Leave Timer (10 - 2147483640) - Time lapse, in milliseconds, that the device waits before leaving its GARP state. Leave time is activated by a Leave All Time message sent/received, and cancelled by the Join message received. Leave time must be greater than or equal to three times the join time. The possible field value is 0-2147483640. The default value is 600 msec. • GARP Leave All Timer (10 - 2147483640) - Time lapse, in milliseconds, that all devices wait before leaving the GARP state. The leave all time must be greater than the leave time. The possible field value is 0-2147483640. The default value is 10000 msec. Defining GARP Timers 1 Open the GARP Timers page. 2 Complete the fields. 3 Click Apply Changes. The GARP parameters are saved to the device. Copying Parameters in the GARP Timers Table 1 Open the GARP Timers page. 2 Click Show All. The GARP Timers Table opens. 3 Select the interface type in the Copy Parameters from field. 4 Select an interface in either the Port or LAG drop-down menu. 5 The definitions for this interface is copied to the selected interfaces. See step 6. 6 Select the Copy to check box to define the interfaces to which the GARP timer definitions are copied, or click Select All to copy the definitions to all ports or LAGs. 7 Click Apply Changes. The parameters are copied to the selected port ports or LAGs in the GARP Timers Table, and the device is updated. Defining GARP Timers Using CLI Commands This table summarizes the equivalent CLI commands for defining GARP timers as displayed in the GARP Timers page. Table 7-18. GARP Timer CLI Commands CLI Command Description garp timer {join | leave | leaveall} Adjusts the GARP application join, timer_value leave, and leaveall GARP timer values. 302 Configuring Device Information