Dell PowerConnect 5448 User's Guide - Page 89
enable, con sntp server, Displaying the SNTP Server Table
View all Dell PowerConnect 5448 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
The following table summarizes the equivalent CLI commands for setting fields displayed in the Add SNTP Server page. Table 6-8. SNTP Server CLI Commands CLI Command sntp server {ipv4-address|ipv6address|hostname [poll] [key keyid] Description Configures the device to use SNTP to request and accept NTP traffic from a server. The following is an example of the CLI commands: console> enable console# configure Console(config)# sntp server 100.1.1.1 poll key 10 Displaying the SNTP Server Table 1 Open the SNTP Servers page. 2 Click Show All. The SNTP Servers Table opens: Figure 6-13. SNTP Servers Table Modifying an SNTP Server 1 Open the SNTP Servers page. 2 Click Show All. The SNTP Servers Table opens. 3 Select an SNTP Server entry. 4 Modify the relevant fields. 5 Click Apply Changes. The SNTP Server information is updated. Configuring System Information 89