Dell PowerConnect 5448 User's Guide - Page 32
Site Requirements, Unpacking, Package Contents, Unpacking the Device
View all Dell PowerConnect 5448 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Site Requirements The device can be mounted in a standard 19-inch rack or placed on a tabletop. Before installing the device, verify that the location chosen for installation meets the site requirements. • General - Ensure that the power supply is correctly installed. • Power - The device is installed within 1.5 m (5 feet) of a grounded, easily accessible outlet 220/110 VAC, 50/60 Hz. • Clearance - There is adequate frontal clearance for operator access. Allow clearance for cabling, power connections and ventilation. • Cabling - Cabling is routed to avoid sources of electrical noise such as radio transmitters, broadcast amplifiers, power lines and fluorescent lighting fixtures. • Ambient Requirements - The ambient unit operating temperature range is 0 to 45ºC (32 to 113ºF) at a relative humidity of 10% to 90%, non-condensing. Verify that water or moisture cannot enter the unit casing. Unpacking Package Contents While unpacking the device, ensure that the following items are included: • The device • An AC power cable • RS-232 crossover cable • Self-adhesive rubber pads • Rack mount kits for rack installation • Documentation CD Unpacking the Device To unpack the device: NOTE: Before unpacking the device, inspect the package and report any evidence of damage immediately. NOTE: An ESD strap is not provided, however it is recommended to wear one for the following procedure. 1 Place the container on a clean, flat surface and cut all straps securing the container. 2 Open the container or remove the container top. 3 Carefully remove the device from the container and place it on a secure and clean surface. 4 Remove all packing material. 5 Inspect the device for damage. Report any damage immediately. 32 Installing the PowerConnect Device