Dell PowerConnect 5448 User's Guide - Page 281
Port Configuration, Show All.
View all Dell PowerConnect 5448 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 281 highlights
Displaying the Port Configuration Table: 1 Open the Port Configuration page. 2 Click Show All. The Ports Configuration Table opens: Figure 7-23. Ports Configuration Table Configuring Ports with CLI Commands The following table summarizes the equivalent CLI commands for configuring ports as displayed in the Ports Configuration Table page. Table 7-12. Port Configuration CLI Commands CLI Command Description interface ethernet interface Enters the interface configuration mode to configure an ethernet type interface. description string Adds a description to an interface configuration. shutdown Disables interfaces that are part of the currently set context. set interface active {ethernet Reactivates an interface that is shutdown due to interface | port-channel port-channel- security reasons. number} speed bps Configures the speed of a given ethernet interface when not using auto negotiation. autobaud Sets the line for automatic baud rate detection. duplex {half | full} Configures the full/half duplex operation of a given ethernet interface when not using auto negotiation. negotiation Enables auto negotiation operation for the speed and duplex parameters of a given interface. back-pressure Enables Back Pressure on a given interface. flowcontrol {auto | on | off | rx | tx} Configures the Flow Control on a given interface. Configuring Device Information 281