Denon AVR-5805MK2 Owners Manual - Page 127

Note on playing a source encoded with DTS • Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. If so, play in the DTS mode. 3 Select the play mode. Example: Stereo Input mode display • In the AUTO mode • In the DIGITAL PCM mode • In the DIGITAL DTS mode Depending on the input signal. (Main unit) (Remote control unit) (Remote control unit) The mode switches as shown below each time the DIRECT/STEREO button on the Main unit is pressed. DIRECT STEREO 4 Start playback on the selected component. • For operating instructions, refer to the component's manual. 5 Adjust the volume. • In the ANALOG mode • In the EXT.IN mode Input signal display • DOLBY DIGITAL • DTS (Main unit) (Remote control unit) M.VOL. -80.0dB The volume level is displayed on the master volume level display. The volume can be adjusted within the range of -80 to +18 dB, in steps of 0.5 dB. However, when the channel level is set as described on pages 51, 52 or 134, 135, if the volume for any channel is set at +0.5 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is "18 dB - (Maximum value of channel level)".) Input mode when playing DTS sources • Noise will be output if DTS-compatible CDs or LDs are played in the "ANALOG" or "PCM" mode. When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to "DTS". • PCM Depending on the input signal. • The DSD indicator lights when the DENON LINK have been connected and the DSD signals have been inputted. (See page 18) Depending on the input signal. • The HDCD indicator lights when digital signals are being input with a player that supports HDCD playback. The DIG. indicator lights when digital signals are being input properly. If the DIG. indicator does not light, check whether the digital input component setup (pages 58, 59) and connections are correct and whether the component's power is turned on. AL24 processing is activated when PCM signals are played while the surround mode is set to PURE DIRECT, DIRECT, STEREO, MULTI CH DIRECT or MULTI CH IN. Advanced AL24 processing is activated when PCM (2-channel) signals are played while the surround mode is set to PURE DIRECT or DIRECT. NOTE: • The DIG. indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard. 127