Denon AVR-5805MK2 Owners Manual - Page 133

[2] Recording Dolby Digital and DTS multichannel sources • With this set it is possible to record Dolby Digital and DTS multichannel signals converted into 2-channel analog signals. • The recording signals are output to the ZONE3 OUT, TAPE and VCR output terminals. • Down-mixed analog signals converted into digital signals are output from the OPTICAL 3, 4 and 5 digital output terminals at this time. 1 Press the ZONE3/4/REC SELECT button until "RECOUT ZONE3 appears on the display. Then select "RECOUT SOURCE". 11 (Main unit) (Main unit) 2 Set the input mode according to the source to be played. 32 (Main unit) (Remote control unit) 3 Set the surround mode by pressing the DIRECT or STEREO button. • The multichannel digital signals are down-mixed and output to the TAPE and VCR output terminals. 3 3 or (Main unit) (Remote control unit) 4 Set the recording mode. (Remote control unit) 2 RC-995 [3] Dolby Headphone recording • When RECOUT mode is set to "source", with the AVR-5805 it is possible to output signals encoded in the Dolby Headphone mode from the recording output terminal and record them on a separate recorder. 1 The Dolby Headphone play mode is set when headphones are connected to the PHONES jack during playback in the DOLBY/DTS surround mode. 2 When this is done, signals encoded in the Dolby Headphone mode are automatically output from the recording output terminals (analog and digital) and can be recorded. 3 Select the parameters and set the desired mode, then record. (Refer to the ⁄0 SURROUND "Dolby Headphone" pages 145, 146.) 1 NOTE: Do not disconnect the headphones during recording. 133