Denon AVR-5805MK2 Owners Manual - Page 130
After starting playback
UPC - 081757507400
View all Denon AVR-5805MK2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
After starting playback [1] Setting the Room EQ 1 The Room EQ switches as follows each time the ROOM EQ button is pressed. (Main unit) OFF Audyssey Front (Remote control unit) Flat Manual See pages 30, 40 for descriptions of the correction curves for the "Room EQ" function. "MultEQ XT" indicator lights green when "Audyssey", "Front" or "Flat" is selected. If you change the "Speaker Configuration", "Delay Time", "Channel Level" or "Crossover Frequency" settings are changed after performing the "Auto Setup" procedure, the "MultEQ XT" indicator lights red. [2] Listening over headphone 1 Plug the headphone' plug into the jack. Connect the headphone to the PHONES jack. The pre-out output (including the speaker output) is automatically turned off when headphones are connected. PHONES 1 NOTE: • To prevent hearing loss, be careful not to raise the volume level excessively when using headphones. [3] Turning the sound off temporarily (MUTING) 1 Use this to mute the audio output temporarily. Press the MUTING button. Muting level is the same level as set with "7-3. Volume Control" (pages 106, 107). (Remote control unit) Cancelling MUTING mode. Press the MUTING button again, or press the volume up or down buttons on the Remote control, or adjust the volume up or down via the front panel volume control knob. [4] Combining the currently playing sound with the desired image (VIDEO SELECT) 1 Press the Remote control unit or Main unit's VIDEO SELECT button until the desired image appears. The video source selected with the video select function is stored in the memory for the different input sources. 130 (Main unit) (Remote control unit) DVD VIDEO SOURCE Cancelling simulcast playback. • Select "SOURCE" using the VIDEO SELECT button. 1 1 1 1 1 1 RC-995