Denon AVR-5805MK2 Owners Manual - Page 39

5 When "Store" is selected, all parameters are stored up. CH SEL ENTER After the data is stored, the "Auto Setup / Room EQ Menu" screen appears automatically. (Main unit) (Remote control unit) NOTE: • Do not turn off the power while the data is being stored. If the power is turned off while the data is being stored, the Room EQ parameters stored in the memory will be cleared, and it will not be possible to select the "Audyssey", "Front" or "Flat" equalizer settings. About the error message • These error messages will be displayed when performing the measurements of Auto Setup and the automatic measurements can not be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items, and measure again. Be sure to turn off the AVR-5805's power before checking the speaker connections. Screen example Cause • The speakers required for producing suitable reproduction have not been detected. q The front L and front R speakers were not properly detected. w Only one channel of the surround (A) and surround (B) speakers was detected. e Sound was output from the R channel when only one surround back speaker was connected. r The surround back or the surround (B) speaker was detected, but the surround (A) speaker was not detected. If multiple errors occur, use the cursor left and right buttons to check the contents. • The speaker polarity is connected in reverse. If multiple errors occur, use the cursor left and right buttons to check the contents. Measures • Check that the pertinent speakers are properly connected. • Check the polarity of the pertinent speakers. • For some speakers, the screen below may be displayed even though the speakers are properly connected. If so, select "Skip0". • There is too much ambient noise in the room and the measurements cannot be made accurately. • Either turn off the power of the device that generated the noise during the measurements or move the device away. • Try again at a time when it is quieter. • The measurement microphone is not connected, or all of speakers have not been detected. • Connect the measurement microphone to the microphone connector. • Check the speaker connection. 39