Fluke 744 Fluke 744 Users Manual - Page 49
Using a Jumper Correctly, Next Choices, ITS-90, IPTS-68 Temperature Scale, WRONG
View all Fluke 744 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
V mA mA V RTD RTD CAT 30V MAX SOURCE 30V MEAS 30V 300V MAX TC MAX MAX WRONG V mA mA V RTD RTD SOURCE 30V MAX MEAS 300V MAX TC V mA mA V RTD RTD SOURCE MEAS 300V MAX TC 30V MAX OK Figure 14. Using a Jumper Correctly gj14f.eps Documenting Process Calibrator Using Measure Mode 8. If necessary, you can change between °C or °F temperature units in Setup mode as follows: a. Press s. b. Press the Next Page softkey twice. c. Use the u and d keys to move the cursor to the parameter you which to change, then press e or the Choices softkey to choose a setting for that parameter. d. Press u or d to move the cursor to the desired setting. e. Press eto go back to the sdisplay. f. Press the Done softkey or s to exit Setup mode. 9. If necessary, you can change between ITS-90 or IPTS-68 Temperature Scale in Setup mode. The procedure is the same as steps a through f above. 39