HP 2605dn HP Color LaserJet 2605/2605dn/2605dtn - Software Technical Reference - Page 303
Optimize Background Toner - drum
View all HP 2605dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 303 highlights
The HP ToolboxFX show a transfer defect while the simplex side does not. These adjustments allow duplex-side defects to be improved without affecting transfer performance on the simplex side (or vice versa). The following settings are available for the Duplex Transfer control. ● Dry paper. This setting increases transfer bias. Some papers (notably Chinese papers) become highly resistive in dry environments. To get enough transfer current into the paper to have good transfer, the transfer bias voltage needs to be increased. The range of paper resistivity in low humidity is so wide that a single standard engine print mode cannot cover all the cases. ● Humid paper. This setting decreases transfer bias. All papers absorb water at higher humidities and become electrically less resistive. This results in transfer defects caused by too much transfer current. The engine has a humidity sensor and also checks the conductivity of the ETB in order to estimate the humidity of the media, but this can be inadequate in more extreme cases. ● Rough paper This setting increases transfer current. Rough papers such as cotton bond papers have a large portion of their surface area spaced away from contact with the OPC drum by their surface texture. In this case, more transfer current is required. ● Less/More transfer (-2, -1, +1, +2) . These settings provide two levels of decreased transfer bias voltage and two levels of increased transfer bias voltage in case the above adjustments aren't enough. They can be used to "hunt" for the best setting. In extreme case (very dry or very wet), low transfer current defects and high transfer current defects can overlap. That is, there won't be a defect free setting. These adjustments can help find the best operating point. ● Toner. This adjustment is applied by the formatter. The following settings are available for the Toner control. ● Less toner (-1, -2, -3) . These settings decrease the maximum primary toner amount for each color (CMYK) from 100% to 95%, 90% and 85%, respectively. This is useful for fixing toner scatter on high-resisitivity papers in low humidity environments. ● Discharge. The following settings are available for the Discharge control. ● On/Off. The HP Color LaserJet 2605 series printer has an electrostatic discharge brush right where the paper separates from the ETB (before the fuser). This prevents toner scatter due to sudden paper discharge. For extreme cases, it could make things worse, so this setting is provided to turn the discharge brush off. Optimize section The Optimize settings are applied to all media printed depending on the engine's internal tables. The following controls are available: ● Background Toner. The On setting selects optimized EP process parameters for reducing background on glossy paper. ● Extra Cleaning. High acid content or "talc" papers tend to leave a conductive residue on the OPC drums. The On setting turns on increased OPC/ETB cleaning rotations before and after pages are printed to help rub off this residue. ● Trailing Edge Over-development (full-speed). The On setting selects optimized EP process parameters for decreasing trailing edge over-development in full speed (Light and Plain media types). Trailing edge over-development is a jump-gap developer defect which causes excess toner at trailing edges of halftoned or solid areas. ENWW The HP ToolboxFX folders 279