HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 111

BM-1007 7 BM-1007 Message , [BM-1007], ,, INFO, , Clearing EX/VEX/FC port configuration for all ports for blade in slot . Probable Cause The specified blade was detected for the first time after an FR4-18i was previously configured in the same slot. The new blade requires the specified port configurations to be cleared. Recommended The blade ports are cleared automatically. No action is required. Action Severity INFO BM-1008 Message , [BM-1008], ,, WARNING, , Download of blade firmware failed for blade in slot . Reissue firmwaredownload to recover. Probable Cause The automatic firmware upgrade on the blade has failed because the blade firmware version was detected to be different from the control processor (CP) firmware version. Recommended Issue the firmwareDownload command to recover the blade. Action Severity WARNING BM-1009 Message , [BM-1009], ,, WARNING, , Firmwaredownload timed-out for application processor. Faulting switch. Probable Cause The firmwareDownload on the application processor (AP) blade failed. Recommended Use the slotPoweroff and slotPoweron commands or reseat the affected blade. On the Brocade Action 7500 or 7600, switch off and on all primary power in order to power-cycle the unit. Severity WARNING BM-1054 Message Probable Cause , [BM-1054], ,, INFO, , AP firmware is not consistent with system firmware . Auto-leveling AP firmware to match system firmware. The policy of the specified blade is set to auto-level the blade firmware to the system firmware, so either: • Blade firmware was detected to be different from CP firmware due to a firmware upgrade • The blade was just inserted and had a different firmware loaded Fabric OS Message Reference 63 53-1000437-01