HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 171

20 FCR-1024 Recommended Action Limit the number of port WWNs required by limiting the remote edge fabric connectivity (which limits the number of translate domains). You can also limit the number of proxy devices for a translate domain (which limits the number of translate domain ports required) by limiting the devices specified in logical storage area network (LSAN) zones. Severity WARNING FCR-1024 Message , [FCR-1024], ,, WARNING, , Local LSAN zone device entries for edge LSAN exhausted. Probable Cause Indicates that the number of devices in a logical storage area network (LSAN) defined in the edge fabric exceeds the local LSAN zone database limitations. Recommended Remove excess device entries from this LSAN zone until the number of devices is within the range Action of the local LSAN zone database limitations. Severity WARNING FCR-1025 Message , [FCR-1025], ,, WARNING, , Local phantom node WWN entries exhausted. Probable Cause Indicates that the number of node world-wide names (WWNs) detected to be in use exceeds the local node WWN resources. Recommended Reduce the number of node WWNs required by limiting the remote edge fabric connectivity (which Action limits the number of translate domains). Severity WARNING FCR-1026 Message , [FCR-1026], ,, INFO, , In slot Node WWN roll over. Probable Cause Indicates that the node world-wide name (WWN) pool has rolled over in the specified slot, and WWN entries detected to not be in use are reused as needed. Recommended Action It is unlikely that WWN conflicts will occur as a result of pool rollover unless the switch is deployed in a very large MetaSAN environment with large number of logical storage area network (LSAN) devices and fabrics, or there are highly dynamic changes to EX_Port connectivity. WWN conflicts might cause unpredictable behavior in management applications. To avoid WWN conflicts, all EX_Ports attached to fabrics with highly dynamic changes to EX_Port connectivity should be disabled then reenabled. Severity INFO Fabric OS Message Reference 123 53-1000437-01