HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 496

77 ZONE-1018 ZONE-1018 Message , [ZONE-1018], ,, ERROR, , Incorrect zoning enforcement type() at port(). Probable Cause Indicates that an incorrect zoning enforcement type was reported on the specified port. This is a software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The valid zone type values are: • hard port zone (value = 1) • hard wwn zone (value = 2) • session based hard zoning (value = 3) • FA zone (value = 5) QuickLoop zones are not supported in Fabric OS v4.x and above. Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Action supportSave command and contact your switch service provider. Severity ERROR ZONE-1019 Message , [ZONE-1019], ,, ERROR, , Transaction Commit failed. Reason code () - \"\" Probable Cause Indicates that the reliable commit service (RCS) had a transmit error. RCS is a protocol used to transmit changes to the configuration database within a fabric. Recommended Action Often this message indicates a transitory problem. Wait a few minutes and retry the command. Make sure that your changes to the zone database are not overwriting the work of another admin. Run the cfgTransShow command to find out if there is any outstanding transaction running on the local switches. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR 448 Fabric OS Message Reference 53-1000437-01