HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 457
SULB-1023, Severity, Message, Probable Cause, firmwareDownload, Recommended, Action, firmwareCommit
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 457 highlights
66 SULB-1023 Severity WARNING SULB-1023 Message , [SULB-1023], AUDIT, WARNING, , The blade in slot has rebooted during firmwaredownload. Probable Cause The error may be caused by an unexpected disruption of the firmwareDownload command, for example, by powering off and on of the indicated BP blade in the middle of a firmwareDownload. The error may also be caused by persistent storage hardware failure or by a software error. Recommended Action firmwareCommit will be started automatically after the blade boots up to repair the secondary partition. If at the end of firmwareCommit, the blade firmware version is still inconsistent with the active CP firmware, firmwareDownload will automatically be restarted on the blade. Run the firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your switch service provider. Severity WARNING SULB-1024 Message , [SULB-1024], AUDIT, WARNING, , Firmware commit has completed on the blade in slot . Probable Cause Indicates that the firmwareCommit operation has completed on the specified blade. Recommended Action Run the firmwareShow command to verify the firmware versions. If the blade firmware is the same as the active CP firmware, firmwareDownload has completed successfully on the blade. However, if the firmwareCommit operation has been started to repair the secondary partition, at the end of firmwareCommit, the blade firmware version may still be inconsistent with the active CP firmware. In that case, firmwareDownload will automatically be restarted on the blade. Run the firmwareDownloadStatus command to monitor the progress. Severity WARNING SULB-1025 Message , [SULB-1025], ,, WARNING, , The blade in slot will reboot with the new firmware. Probable Cause Indicates that new firmware has been downloaded to the specified AP blade and that the AP blade will reboot to active it. Recommended Wait for the blade to reboot. Action Severity WARNING Fabric OS Message Reference 409 53-1000437-01