HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 153

14 FABS-1013 FABS-1013 Message , [FABS-1013], ,, ERROR, , []:Unknown blade type 0x Probable Cause An unrecognized type of blade has been discovered in the system. This may be caused by an incorrect FRU header, inability to read the FRU header, or the blade may not be supported by this platform or Fabric OS version. Recommended Action Verify that the blade is valid for use in this system and this version of Fabric OS. Try reseating the blade. If this is a valid blade and reseating does not fix the problem, then replace the blade. Severity ERROR FABS-1014 Message , [FABS-1014], ,, ERROR, , []:Unknown FRU type 0x Probable Cause An unrecognized type of FRU has been discovered in the system. This may be caused by an incorrect FRU header, inability to read the FRU header, or the FRU may not be supported by this platform or Fabric OS version. Recommended Action Verify that the FRU is valid for use in this system and this version of Fabric OS. Try reseating the FRU. If this is a valid FRU and reseating doesn't help, then replace the FRU. Severity ERROR FABS-1015 Message , [FABS-1015], ,, ERROR, , []:Request to enable FRU type 0x, unit failed. err code Probable Cause Indicates the specified FRU could not be enabled. This is usually an internal Fabric OS problem. Recommended Action Try removing and reinserting the FRU. Reboot or power-cycle the CP or system. If the message persists, run the firmwareDownload command to update the firmware. Severity ERROR Fabric OS Message Reference 105 53-1000437-01