HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 454

66 SULB-1009 Table 8 lists the firmwareDownload state names and state values. They indicate where in the firmwareDownload process the error occurred. TABLE 8 Upgrade State and Code Value Upgrade State Code SUS_PEER_CHECK_SANITY SUS_PEER_FWDL_BEGIN SUS_SBY_FWDL_BEGIN SUS_PEER_REBOOT SUS_SBY_REBOOT SUS_SBY_FABOS_OK SUS_PEER_FS_CHECK SUS_SELF_FAILOVER SUS_SBY_FWDL1_BEGIN SUS_SELF_FWDL_BEGIN SUS_SELF_COMMIT SUS_SBY_FWC_BEGIN SUS_SBY_COMMIT SUS_SBY_FS_CHECK SUS_ACT_FWC_BEGIN SUS_PEER_RESTORE_BEGIN SUS_SBY_RESTORE_BEGIN SUS_PEER_FWC_BEGIN SUS_PEER_FS_CHECK1 SUS_FINISH SUS_COMMIT 0x21 0x22 0x23 0x24 0x25 0x26 0x27 0x28 0x29 0x2a 0x2b 0x2c 0x2d 0x2e 0x2f 0x30 0x31 0x32 0x33 0x34 0x35 Recommended Action Run the firmwareDownloadStatus command for more information. In a director-class switch, when firmwareDownload fails, the command will synchronize the firmware on the two partitions of each CP by starting a firmware commit operation. Wait until this operation completes (about 10 minutes) before attempting another firmwareDownload. In a director-class switch, when firmwareDownload fails, the two CPs may end up with different versions of firmware and they may not gain high-availability (HA) sync. In that case, run firmwareDownload single mode (-s) to upgrade the firmware on the standby CP to the same version as the active CP. Then retry firmwareDownload to download the desired version of firmware onto the CPs. Refer to the Fabric OS Administrator's Guide for troubleshooting information. Severity INFO 406 Fabric OS Message Reference 53-1000437-01