HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 73

AG System Messages Chapter 2 AG-1001 Message , [AG-1001], ,, ERROR, , N_Port ID virtualization (NPIV) is not supported by fabric port connected to port . Probable Cause N_Port ID virtualization (NPIV) capability is not supported by the fabric port to which the Access Gateway is connected. Recommended Action • On Brocade, Fabric OS based switches execute the portCfgNpivPort command on the fabric switch to enable NPIV capability on the port connected to the Access Gateway. Refer to the Fabric OS Command Reference manual for more information on this command. • Some blades within a switch or some ports within a switch or blade may not have support for NPIV capability. NPIV functionality cannot be enabled on such ports and they will not respond to NPIV requests. refer to the Access Gateway Administrator Guide, Appendix B for specific AG compatibility requirements. • On non-Brocade switches, refer to the manufacture's documentation to determine whether the switch supports NPIV and how to enable NPIV on these types of switches. Severity ERROR AG-1002 Message , [AG-1002], ,, WARNING, , Unable to find alternate N_Port during failover for N_Port . Probable Cause No other N_Port is configured or the fabric was unstable during failover. Recommended Action Please check whether or not an alternate N_Port is configured. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING AG-1003 Message , [AG-1003], ,, WARNING, , Unable to failover N_Port . Failover across different fabrics is not supported. Probable Cause Failover across N_Ports connected to different fabrics is not supported. Recommended Please configure two or more N_Ports to connect to the same fabric; then execute ag Action --failoverEnable to enable failover on these N_Ports. Fabric OS Message Reference 25 53-1000437-01