HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 442

63 SEC-1331 Recommended Verify that the distribution is initiated by the primary FCS switch. Use the secPolicyShow command Action to verify and correct the configuration if necessary. Severity ERROR SEC-1331 Message , [SEC-1331], ,, ERROR, , Attempt to enable secure mode failed. Reason: . Probable Cause Indicates that the secModeEnable command failed on the fabric, because default IP Filter policies are not active on the switch, or an active transaction exists on IP Filter policies. Recommended Action Verify that the security event was planned. If the security event was planned, run the ipfilter --activate default_ipv4 or the ipfilter --activate default_ipv6 command to activate default IP Filter Policies. Use the ipfilter --save or the ipfilter --transabort commands to save or abort any active transaction on IP Filter policies. Then retry the secModeEnable command. Severity ERROR 394 Fabric OS Message Reference 53-1000437-01