HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 277

27 FW-1431 FW-1431 Message , [FW-1431], ,, WARNING, , Switch status change contributing factor Fan: bad. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of faulty fans is greater than or equal to the policy set by the switchStatusPolicySet command. A fan is faulty when sensor value is not in the acceptable range or is faulty. Recommended Replace the faulty or deteriorating fan field-replaceable units (FRUs). Action Severity WARNING FW-1432 Message , [FW-1432], ,, WARNING, , Switch status change contributing factor WWN: bad. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of faulty world-wide name (WWN) cards is greater than or equal to the policy set by the switchStatusPolicySet command. Recommended Replace the faulty WWN card. Action Severity WARNING FW-1433 Message , [FW-1433], ,, WARNING, , Switch status change contributing factor CP: CP non-redundant. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of faulty CPs is greater than or equal to the policy set by the switchStatusPolicySet command. The CPs are non-redundant. If you power cycle a Brocade 24000 chassis in dual-domain configuration, and then reset the micro-switch of the active CP before the heartbeat is up, this will cause both CPs to come up in a non-redundant state. Recommended Action Run the firmwareShow command to verify that both CPs have compatible firmware levels. Run the firmwareDownload command to install the same level of firmware to both CPs. Replace any faulty CPs. If you reset the micro-switch (the latch on the CP blade) on the active CP before the heartbeat was up on a power cycle, and the CPs came up non-redundant, then you should reboot the CPs again to clear the problem. Severity WARNING Fabric OS Message Reference 229 53-1000437-01