HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 125

11 EM-1018 EM-1018 Message , [EM-1018], , FFDC, CRITICAL, , CP blade in slot failed to retrieve current chassis type (//0x). Probable Cause Indicates that there was a failure to read the chassis type from the system. Recommended Verify that the control processor (CP) blade is operational and is properly seated in its slot. Action Severity CRITICAL EM-1019 Message , [EM-1019], ,, WARNING, , Current chassis configuration option () is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync. Probable Cause Indicates that the current chassisConfig option is not supported by the firmware on the standby control processor (CP). This is true even if the standby comes up and appears to be operational. High availability (HA) synchronization of the CPs will not be allowed. Recommended Either change the chassisConfig option to 1 with the chassisConfig command, or upgrade the Action firmware on the standby to the version running on the active CP. Severity WARNING EM-1028 Message , [EM-1028], , FFDC, CRITICAL, , HIL Error: failed to access history log for FRU: (rc=). Probable Cause Indicates a problem accessing the data on the world-wide name (WWN) card field-replaceable unit (FRU), or the WWN card storage area on the main logic board. The problems were encountered when the software attempted to write to the history log storage to record an event for the specified FRU. The return code is for internal use only. This is a serious hardware problem. The FRU ID value is composed of a FRU type string and an optional number to identify the unit, slot, or port. Recommended Action If the message persists, reboot or power cycle the switch. If the message still persists, replace the WWN card, or the switch (for nonbladed switches). Severity CRITICAL Fabric OS Message Reference 77 53-1000437-01