HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 161

Chapter FCPD System Messages 18 FCPD-1001 Message , [FCPD-1001], ,, WARNING, , Probing failed on . Probable Cause Indicates that a fibre channel protocol (FCP) switch probed devices on a loop port, and the probing failed on the either the L_Port, AL_PA address, or the F_Port. For the AL_PA, the valid range is 00 through FF. The error string can be either: • L_Port port_number ALPA alpa_number • F_Port port_number Recommended This can happen when the firmware on the device controller on the specified port has a defect. Action Check with the device vendor for a firmware upgrade containing a defect fix. Severity WARNING FCPD-1002 Message , [FCPD-1002], ,, WARNING, , port , bad R_CTL for fcp probing: 0x Probable Cause Indicates that the response frame received on the specified port for a inquiry request contains an invalid value in the routing control field. Recommended This can happen only if the firmware on the device controller on the specified port has a defect. Action Check with the device vendor for a firmware upgrade containing a defect fix. Severity WARNING FCPD-1003 Message , [FCPD-1003], ,, INFO, , Probing failed on which is possibly a private device which is not supported in this port type Probable Cause Private devices will not respond to the switch port login (PLOGI) during probing. Recommended Action The Brocade 4100, 4900, 5000, 7500, and AP 7600 do not support private loop devices. Refer to the switch vendor for a list of other port types that support private devices for inclusion into the fabric. Severity INFO Fabric OS Message Reference 113 53-1000437-01