HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 406

63 SEC-1095 SEC-1095 Message , [SEC-1095], ,, ERROR, , Deleting FCS policy is not allowed. Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configurations server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1096 Message , [SEC-1096], ,, ERROR, , Failed to delete because Probable Cause Indicates that a policy cannot be removed because deleting it would result in invalid security policy configuration. Recommended Verify the security policy configuration requirements and remove any policies that require the policy Action you want to remove first. Severity ERROR SEC-1097 Message , [SEC-1097], ,, ERROR, , Cannot find policy set. Probable Cause Indicates that the specified policy could not be found. Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Action supportSave command and contact your switch service provider. Severity ERROR 358 Fabric OS Message Reference 53-1000437-01