HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 539

83 SULB-1033 SULB-1033 Message AUDIT, , [SULB-1033], WARNING, FIRMWARE, , , , Switch has completed relocating the internal firmware image. Probable Cause Indicates that the firmwareDownload process has completed normally on the switch. Recommended Run the firmwareShow command to verify the firmware versions. Run the switchShow command to Action make sure the switch is enabled. Severity WARNING SULB-1034 Message AUDIT, , [SULB-1034], ERROR, FIRMWARE, , , , Firmwaredownload timed out. Probable Cause The error may be caused by a switch initialization issue after the internal image is relocated. It may also be caused by an internal Ethernet issue or by persistent storage failure. Recommended Action Reboot the switch. This will cause the internal image to be relocated again. Use the firmwareDownloadStatus to monitor the progress. If the problem persists, contact your switch service provider. Severity ERROR SULB-1035 Message AUDIT, , [SULB-1035], ERROR, FIRMWARE, , , , An error has occurred relocation of the internal image. Probable Cause Indicates that an error has occurred during the relocation of the internal image. The error may be caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or persistent storage hardware failure. Recommended Reset the switch. This will cause the internal image to be relocated again. If the problem persists, Action contact your switch service provider. Severity ERROR SULB-1037 Message AUDIT, , [SULB-1037], ERROR, FIRMWARE, , , , HCL failed. Reboot the switch manually using the reboot command. However, it will disrupt the FC traffic. Probable Cause Many reasons can cause HCL to fail, such as domain not confirmed. Recommended Run the reBoot command to reboot the switch manually. Action Fabric OS Message Reference 491 53-1000437-01