HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 458

66 SULB-1026 SULB-1026 Message , [SULB-1026], , AUDIT, WARNING, , Firmware commit operation started on the blade in slot . Probable Cause firmwareCommit has started on the specified blade. The operation may be a normal part of firmwareDownload, or it may have started to repair the secondary partition of the blade if the secondary partition is corrupted. Recommended No action is required. Action Severity WARNING SULB-1030 Message , [SULB-1030], AUDIT, WARNING, , The switch has rebooted during relocating the internal firmware image. Probable Cause The error may be caused by an unexpected disruption of the firmwareDownload command, for example, by powering the switch off and on in the middle of a firmwareDownload. The error may also be caused by persistent storage hardware failure or by a software error. Recommended firmwareDownload will continue after the switch has rebooted. Run the firmwareDownloadStatus Action command to monitor progress. If the problem persists, contact your switch service provider. Severity WARNING SULB-1031 Message , [SULB-1031], , AUDIT, WARNING, , The switch is relocating an internal firmware image. Probable Cause Indicates that the switch has rebooted with the new firmware and is relocating the AP firmware. Recommended Wait for the operation to complete. Action Severity WARNING SULB-1033 Message , [SULB-1033], , AUDIT, WARNING, , Switch has completed relocating the internal firmware image. Probable Cause Indicates that the firmwareDownload process has completed normally on the switch. Recommended Run the firmwareShow command to verify the firmware versions. Run the switchShow command to Action make sure the switch is enabled. 410 Fabric OS Message Reference 53-1000437-01