HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 112

7 BM-1055 Recommended No action is required. The blade will automatically download the updated firmware. Action Severity INFO BM-1055 Message , [BM-1055], ,, WARNING, , Firmwaredownload timed-out for AP. Faulting switch. Probable Cause The firmwareDownload command on the application processor (AP) blade failed. Recommended Use the slotPoweroff and slotPoweron commands or reseat the affected blade. On the Brocade Action 7500 or 7600, switch off and on all primary power in order to power-cycle the unit. Severity WARNING BM-1056 Message , [BM-1056], ,, INFO, , AP is not configured. Persistently disabling all ports on the switch. Probable Cause The policy of the specified switch is to persistently disable all ports the first time the application processor (AP) blade is detected. This may be cause by one of the following: • The AP was detected for the first time on this switch. • The switch was configured under a different mode. Recommended Configure the switch to persistently enable all ports. Action Severity INFO BM-1058 Message , [BM-1058], ,, WARNING, , Download of AP firmware failed for the switch. Reissue firmwaredownload to recover. Probable Cause The automatic firmware upgrade on the application processor (AP) has failed because the firmware version running on the AP was detected to be different from system firmware due to a firmware upgrade. Recommended Issue the firmwareDownload command to recover the AP. Action Severity WARNING 64 Fabric OS Message Reference 53-1000437-01