HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 408

63 SEC-1101 SEC-1101 Message , [SEC-1101], ,, ERROR, , Failed to enable security on all switches. Please retry later. Probable Cause Indicates that the security enable failed on the fabric because one or more switches in the fabric are busy. Recommended Action Verify that the security event was planned. If the security event was planned, run the secFabricShow command to verify that all switches in the fabric are in the ready state. When all switches are in the ready state, retry the operation. Severity ERROR SEC-1102 Message , [SEC-1102], ,, ERROR, , Fail to download . Probable Cause Indicates that the switch failed to download certificate, security database, or policies. This can happen when switch does not get enough resources to complete the operation, fabric has not stabilized, or policy database is an invalid format. Recommended Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal Action format (with configDownload), correct the format and retry the operation. Severity ERROR SEC-1104 Message , [SEC-1104], ,, ERROR, , Fail to get primary . Probable Cause Indicates that the switch failed to get either the primary certificate or a primary public key. Recommended Action Verify that the primary switch has a valid certificate installed and retry the operation. If a valid certificate is not installed, install a certificate by following the procedure specified in the Secure Fabric OS Administrator's Guide. Severity ERROR 360 Fabric OS Message Reference 53-1000437-01