HP StorageWorks 2/32 Brocade Fabric OS Message Reference - Supporting Fabric O - Page 499

77 ZONE-1028 ZONE-1028 Message , [ZONE-1028], ,, WARNING, , Commit zone DB larger than supported - greater than . Probable Cause Indicates that the zone database size is greater than the limit allowed by the fabric. The limit of the zone database size depends on the lowest level switch in the fabric. Older switches have less memory and force a smaller zone database for the entire fabric. Recommended Action Edit the zone database to keep it within the allowable limit for the specific switches in your fabric. Refer to the Fabric OS Administrator's Guide for information on the zone database sizes supported for each switch. Severity WARNING ZONE-1029 Message , [ZONE-1029], ,, WARNING, , Restoring zone cfg from flash failed - bad config saved to []. Probable Cause Indicates that the zone configuration restored from the flash was faulty. Recommended Action This error will save the faulty zone configuration in the zoned core file directory. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING ZONE-1030 Message , [ZONE-1030], ,, WARNING, , Converting the zone db for PID format change failed. Probable Cause Indicates that the current zone database could not be converted to reflect the PID format change. Most likely this is caused by the size of the zone database. Recommended Change the PID format back to its original format. Reduce the size of the zone database. Then you Action can change the PID format to the requested format. Severity WARNING Fabric OS Message Reference 451 53-1000437-01