Icom IC-9700 Instruction Manual advanced - Page 161
Troubleshooting for the Access Point mode operation, Dealer or Service Center.
View all Icom IC-9700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
11. ABOUT THE DV GATEWAY FUNCTION Troubleshooting DDTroubleshooting for the Access Point mode operation The following chart is designed to help you correct problems which are not equipment malfunctions. If you are unable to locate the cause of a problem or solve it through the use of this chart, contact your Icom Dealer or Service Center. PROBLEM POSSIBLE CAUSE After your call, the repeater •• The wrong Access Point is selected does not return a status reply. in the Remote D-STAR transceiver. (No S-meter indication) •• The manually entered frequency or duplex setting is wrong in the Remote D-STAR transceiver. •• The transmission from the Remote D-STAR transceiver did not reach the Access Point. •• Transceiver connection is wrong. •• The Remote D-STAR transceiver's call sign has not been added to "Allowed Call Sign List" in the transceiver, RS-MS3W, or RSMS3A, when "Allowed Call sign" is set to "Enable." After your call, the repeater replies "UR?," the Access Point call sign and ID suffix "G." •• When using the External Gateway function, you did not click (touch) in the RS-MS3W or RS-MS3A. •• The call was successfully sent to the Access Point, but no station immediately replied. SOLUTION •• Set the correct Access Point to "FROM." •• Set the correct frequency or duplex setting. •• Move to the place where the Remote D-STAR transceiver can reach the Access Point. •• When using the Internal Gateway function, check the connection between the transceiver and the router. •• When using the External Gateway function, check the connection between the transceiver and the Windows device, or the transceiver and the Android device. •• When using the Internal Gateway function, add the Remote D-STAR transceiver's call sign to "Allowed Call Sign List" in the INTERNAL GATEWAY SETTINGS screen. •• When using the External Gateway function, add the Remote D-STAR transceiver's call sign to "Allowed Call Sign List" in the RS-MS3W or RS-MS3A. •• Click (touch) in the RSMS3W or RS-MS3A. •• Wait for a while, and try again. REFERENCE - - - p. 11-8 pp. 11-10, 11-11 p. 11-8 RS-MS3W, RS-MS3A's instruction manual RS-MS3W, RS-MS3A's instruction manual - 11-22