Lexmark Optra C710 Setup Guide - Page 47

Note: The hinge point of the access door is at the bottom of the rear duplex assembly. The door opens away from the rear of the printer. Rear duplex assembly Access door 2 Align the holes in the support brackets and the holes on the bottom of the rear duplex assembly with the pins on the rear of the output bin and the pins on the duplex unit base. 3 Lower the rear duplex assembly onto the pins and connector of the duplex unit base until the rear duplex assembly snaps into place. Alignment pin Access door hinge point Alignment pins Alignment pin covers 4 Place the previously removed alignment pin cov- ers over the support brackets as shown. The covers snap into place when aligned and pressed down. If the alignment pin covers are difficult to install, make sure the rear duplex assembly is fully seated and the brackets are properly aligned on the pins. Repeat steps 2 and 3 if necessary. Installing the rear assembly 43