Lexmark Optra C710 Setup Guide - Page 48

Installing the topassembly, duplex assembly.

Get Lexmark Optra C710 PDF manuals and user guides View all Lexmark Optra C710 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 48 highlights

Installing the top assembly Pad 1 Place the bridge block onto the forward pad in the output bin as shown. The hinged side of the bridge block must be toward the rear of the printer for correct installation. The bridge block may be squeezed together to make placement on the pad easier. The bridge block has a small magnetic pad on the bottom that must rest on the metal pad in the front of the output bin. Alignment pins and connector 2 Align the pins and connector of the top duplex assembly with the holes and connector on the rear duplex assembly. 3 Lower the pins of the top duplex assembly into the holes of the rear duplex assembly until the top duplex assembly snaps into place. 44 Installing the top assembly

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
44
Installing the top assembly
Installing the
top assembly
1
Place the bridge block onto the forward pad in the
output bin as shown.
The hinged side of the bridge block must be toward
the rear of the printer for correct installation.
The bridge block may be squeezed together to make
placement on the pad easier.
The bridge block has a small magnetic pad on the
bottom that must rest on the metal pad in the front
of the output bin.
2
Align the pins and connector of the top duplex
assembly with the holes and connector on the rear
duplex assembly.
3
Lower the pins of the top duplex assembly into the
holes of the rear duplex assembly until the top
duplex assembly snaps into place.
Pad
Alignment pins and connector