Panasonic HVX200A Operating Instructions - Page 17

Installing and removing the power supply Installing and removing the battery Installation Insert the battery until it clicks into place. Removal 1 Set the POWER switch to OFF, and check that the mode lamp is off. 2 Remove the battery while pressing the battery release button. • Support the battery with your hand to ensure that it will not fall. Preparation Mode lamp Battery release button Connecting and disconnecting the power cord Installation 1 Connect the DC cord to the AC adapter. 2 Plug the AC power supply into the power outlet. 3 Insert the DC cord's battery connector until it clicks into place. Removal 1 Set the POWER switch to OFF, and check that the mode lamp is off. 2 Remove the DC cord's battery connector while pressing the battery release button. 3 Disconnect the AC power supply cord from the power outlet. • You cannot charge the battery when supplying power to the camera-recorder from the AC adapter. DC cord's battery connector CAUTION: • This unit can be operated at a voltage in the range of 100-240V AC. An AC plug adapter may be required for voltages other than 120 V AC. If a conversion plug is required, consult with your dealer as to which one is to be purchased. • Disconnect the AC power supply cord from the power outlet when the unit is not going to be used. 17