Pioneer PDP-6010FD Owner's Manual - Page 26
of the hung on wall unit.
View all Pioneer PDP-6010FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
05 Preparation When using the hung on wall unit (PDP-5010FD) Note • First lay the plasma display on top of a soft sheet etc., remove the stand, then attach the speaker mounting fittings. 1 Attach the speaker mounting fittings to the rear of the plasma display (See step 1 on page 23). 2 Connect the supplied speaker cables to the rear of the plasma display (See step 4 on page 25). 3 Place the plasma display on the mounting fittings of the hung on wall unit. For details, refer to the instruction manual supplied with the hung on wall unit. Caution • Be careful about the speaker mounting fittings when installing or connecting. This may result in injury. 4 Connect the other end of the speaker cables to the speaker (See step 5 on page 25). Caution • Have two people perform this procedure. 5 Fit the speaker to the mounting fittings the correct direction. Caution • Be sure not to mount the speaker upside down. 6 Tighten from below using the supplied screws (three locations). • Tighten the three screws in order , , as shown in the drawing. The screw hole at the rear surface of the speaker mounting fitting is used when the plasma display is installed with the table top stand. It is not used when installed on the wall. Note • If after attaching the speaker its position needs to be adjusted horizontally, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. 7 Bundle the cables. • Bead bands are included with the plasma display. • Use the bead bands as necessary. • When tidying up your speaker cables, make sure to bundle them so that they are not subjected to any pressure. 3 Speaker mounting screw (M5 x 10 mm) When using the hung on wall unit, do not use this hole. 1 Speaker mounting screw (M5 x 10 mm) 26 En 2 Speaker mounting screw (M5 x 10 mm)