Pioneer PDP-6010FD Owner's Manual - Page 33

Basic Operations 06 English Chapter 6 Basic Operations Turning on the power • Turn a on on the plasma display when the POWER ON and STANDBY indicators are off (see Part Names on pages 14 and 15). • The system is on. • The POWER ON indicator lights up blue. • Press TV a on the remote control unit or STANDBY/ON on the plasma display when the STANDBY indicator lights up red. • The POWER ON indicator lights up blue. Caution • While the POWER ON and STANDBY indicators are off, the system cannot be placed into the power-on mode even when TV a or STANDBY/ON button is pressed. Turn a on on the plasma display. • The plasma display will still consume some power as long as the power cord is inserted into the power outlet. Plasma display (PDP-6010FD) POWER ON indicator Turning off the power (to standby mode) 1 Press TV a on the remote control unit or STANDBY/ON on the plasma display. • The system enters the standby mode and the image on the screen disappears. • The STANDBY indicator lights up red. • This will allow the system to automatically receive digital TV program information while in the standby mode. Note • If you are not going to use this system for a long period of time, remove the power cord from the power outlet. Plasma display status indicators The table below shows the operational status of the plasma display. You can check the current status of the system with the indicators on the plasma display. Indicator Status System Status POWER ON STANDBY The power cord of the plasma display has been disconnected. Or, the power cord of the plasma display has been connected but the a button of the plasma display is off. Power to the system is on. ON STANDBY SLEEP STANDBY indicator a button (PDP-5010FD) POWER ON indicator STANDBY indicator ON STANDBY SLEEP a button (located at the bottom on the rear panel. See page 15.) The system is in the standby mode. For other than the above, see Troubleshooting on page 93. Note • You can select "Auto", "High", "Mid" or "Low" for the brightness of the POWER ON indicator. When "Auto" is selected, the brightness of the indicator changes to "High", "Mid" or "Low" to match the brightness level of the viewing area. For details, see Blue LED Dimmer on page 69. STANDBY/ON button (Right side view) 33 En