Pioneer PDP-6010FD Owner's Manual - Page 28

05 Preparation Detaching the Pioneer stand • When removing the stand before you install the speaker, begin with step 2. • Besides the speaker, steps for detaching the stand are the same for PDP-6010FD and PDP-5010FD. 1 Detach the supplied speaker if it has already been installed. • To detach the speaker, remove the cable wiring for the speaker at the rear and screws at the rear of the speaker and pull it out (see step 3 on page 20 for PDP-6010FD or steps 3 on page 24 for PDP-5010FD). Installation bolts (1) (Step 1) Installation bolts (2) (Step 2) (PDP-5010FD) • Use the protective sheet in which the speaker was wrapped between the speaker and stand. • Make sure to remove the speaker mounting fittings. 2 With the plasma display lying flat, loosen and remove the two installation bolts (1) and (2) using a screwdriver. Installation bolt (1): M8 x 23 mm (black) for PDP-5010FD M6 x 20 mm (black) for PDP-6010FD Installation bolt (2): M8 x 40 mm (black) for PDP-5010FD M6 x 20 mm (black) for PDP-6010FD Installation bolts (1) (Step 1) Installation bolts (2) (Step 2) 3 Remove the stand from the plasma display. Note • Make sure to keep the installation bolts (1) and (2) that have been removed as they are re-used when attaching the stand to the plasma display. • Place a sheet or protective cover to protect the display from scratches or damage. • Work only with the plasma display lying flat on a table or similar surface. • When lying the plasma display down, be careful not to scratch or damage it. Attaching the stand again • When the plasma display is mounted without the supplied speaker, begin with step 2. • Besides the speaker, steps for attaching the stand are the same for PDP-6010FD and PDP-5010FD (use the screw holes with "T" inscribed). 1 Detach the supplied speaker when the plasma display is being mounted on the wall, with the speaker attached. • To detach the speaker, remove the cable wiring for the speaker at the rear and screws at the bottom of the speaker and pull it out (see illustrations on page 22 for PDP-6010FD and on page 26 for PDP-5010FD). (PDP-6010FD) 28 En