Pioneer PDP-6010FD Owner's Manual - Page 64

11 Adjustments and Settings Sound Effect You can select from SRS FOCUS, SRS or SRS TruBass. 1 Press HOME MENU. 2 Select "Sound" ( / then ENTER). 3 Select "Sound Effect" ( / then ENTER). 4 Select "SRS FOCUS", "SRS" or "SRS TruBass" ( / ). 5 Select the desired parameter ( / ). SRS FOCUS Selections Off On Deactivates SRS FOCUS® Activates SRS FOCUS® Shifts the apparent direction of the sound upward for more clearly defined sound SRS Selections Off On Deactivates SRS® Activates SRS® Reproduces highly effective threedimensional sound SRS TruBass Selections Off On Deactivates SRS TruBass® Activates SRS TruBass® Provides deep, rich bass using a new technology 6 Press HOME MENU to exit the menu. Note • (WOW) denotes a status where SRS FOCUS®, SRS® and SRS TruBass® are on. • You cannot adjust the sound effect for listening with headphones. • If you change the sound effect with headphones connected, the new setting will become effective as soon as you disconnect the headphones. • The effect of this function differs depending on signals. 64 En Power Control Power Control provides convenient functions for saving power. Energy Save You may use one of the three Energy Save modes to save power consumption. 1 Press HOME MENU. 2 Select "Power Control" ( / then ENTER). 3 Select "Energy Save" ( / then ENTER). 4 Select "Mode 1", "Mode 2", or "Picture Off" ( / then ENTER). Item Off Mode 1 Description Does not decrease picture brightness Slightly lowers power consumption while slightly suppressing the brightness drop level Mode 2 Picture Off Decreases the picture brightness and lowers power consumption Deactivates the screen to save power. To restore the screen display, press any button other than VOL +/- and MUTING. This setting is not memorized by the system. 5 Press HOME MENU to exit the menu. Note • When you change the Energy Save mode, you may notice a change in the panel sound. This is normal. • Energy Save maintains efficiency of the screen for a long period of time by decreasing picture brightness and lowering power consumption. Setting Energy Save to "Mode 1" is recommended for increased efficiency. No Signal off (AV source only) The system will be automatically placed into the standby mode if no signal is received for 15 minutes. 1 Press HOME MENU. 2 Select "Power Control" ( / then ENTER). 3 Select "No Signal off" ( / then ENTER). 4 Select "Enable" ( / then ENTER). Item Disable (default) Enable Description Does not place the system into the standby mode Places the system into the standby mode if no signal is received for 15 minutes 5 Press HOME MENU to exit the menu. Note • Five minutes before the system is placed into the standby mode, a message appears every minute. • The system may not be placed into the standby mode when noise signals are present at the plasma display after a TV program finishes.