Pioneer PDP-6010FD Owner's Manual - Page 27

Preparation 05 English 8 mm to 15 mm (3/8 inch to 5/8 inch) 4 mm (5/32 inch) M8 Preventing the plasma display from falling over After installing the stand, be sure to take special care to ensure that the plasma display will not fall over and is stabilized to both the wall and rack. Stabilizing on a table or rack Stabilize the plasma display as shown in the diagram using the supplied plastic bands and screws. Note • To stabilize the plasma display on a table or rack, also use commercially available wood screws that have a nominal diameter of 4 mm (5/32 inch) and that are at least 20 mm (13/16 inch) long. (PDP-6010FD) 20 mm (13/16 inch) min. Supplied screw (M4 x 10 mm: black) Wood screw (commercially available, 4 mm x 20 mm (5/32 inch x 13/16 inch) min.) Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides. (PDP-5010FD) 4 5 Supplied screw Wood screw (M4 x 10 mm: black) (commercially available, 4 mm x 20 mm (5/32 inch x 13/16 inch) min.) Using a wall for stabilization 1 Attach falling prevention bolts (hooks) to the plasma display. 2 Use strong cords to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. Note • Use hooks, cords and fittings that are available on the market. Recommended hook: Nominal diameter 8 mm (3/8 inch), length 12 mm to 18 mm (0.5 inches to 0.7 inches). 1. Hook 2. Cord Fitting 12 mm to 18 mm (0.5 inches to 0.7 inches) 4 5 Caution • A table or rack with adequate strength should always be used to support the plasma display. Failure to do so could result in personal injury and physical damage. • When installing the plasma display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents. • If you do not take these precautions, the plasma display could fall down and cause injury. • The screws, hooks, cords and other fittings that you use to secure the plasma display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached. • Select the appropriate screws, hooks, cords, and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary. Supplied screw Wood screw Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides. 27 En