Ricoh FW780 Service Manual - Page 252
Clear Mode key [A], toner end indicators will blink SP INPUT/OUTPUT mode.
View all Ricoh FW780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 252 highlights
INSTALLATION PROCEDURE [A] [C] [D] [B] [E] A252I508.WMF NOTE: If the fusing temperature is lower than 60°C when the main switch is turned on, the main motor will rotate. In this case, it is not necessary to access the SP mode to load the total 2kg of developer (Steps 11 to 14). Turn off the main switch to stop the main motor after the developer is loaded from the development entrance. Then, pour in another kg of developer. 11. Press the following keys on the operation panel: Clear Mode key [A] + key [B] + key Clear/Stop key [C] 12. Press the Clear/Stop key again for longer than 3 seconds. The wrench and toner end indicators will blink (SP INPUT/OUTPUT mode). 13. Select 23 using the + key and - key [D] and press the RF Select key [E]. The main motor will rotate. 14. Press the RF Select key to stop the main motor after the developer is loaded from the development entrance. Pour in another kg of developer into the development unit evenly across its width (Total: 2 kg). Press the Clear Modes/Stand by key 3 times to leave the SP mode. A251/A252 3-8 SM