Ricoh FW780 Service Manual - Page 380

SERVICE TOOLS Mode No. Roll Feeder Cutting Length Adjustment (1,100 mm, Plain Paper) Function Adjusts the cutting length of 1,100 mm in the plain paper mode. When this value is changed, the values for SP46 and SP47 are automatically changed according to the following table: Inch versions Meter versions SP45 X SP45 X SP46 X - 1.0 SP46 X - 2.4 SP47 X + 0.8 SP47 X + 0.8 Data 0: Standard -50 ← 0 → 50 mm Longer Shorter 45 If the settings in SP46 or SP47 exceed the maximum and/or minimum values, the maximum or minimum values are used instead. Note: The value for the 1st roll feed can only be input when the corresponding indicator is blinking (same for 2nd roll feed). Use the Function Select Key to switch between the two indicators. Roll Feeder Cutting To adjust the cutting length of 1,100 Length Adjustment mm in the translucent paper mode. (1,100 mm, Translucent Paper) Note: 46 The value for the 1st roll feed can only be input when the corresponding indicator is blinking (same for 2nd roll feed). Use the Function Select Key to switch between the two indicators. Roll Feeder Cutting To adjust the cutting length of 1,100 Length Adjustment mm in the translucent film mode. (1,100 mm, Translucent Film) 47 Note: The value for the 1st roll feed can only be input when the corresponding indicator is blinking (same for 2nd roll feed). Use the Function Select Key to switch between the two indicators. Semi-synchro-cut Adjusts the cut length in the semi48 Length Adjustment synchro cut mode (B047 copier only). -10 ← 0 → 10 Shorter Longer 0.1 %/step Main Motor Speed Changes the main motor speed. Adjustment 49 0: Standard -9 ← 0 → 11 Slower Faster When making long copies, if the main motor speed is incorrect, rJ98 or rJ99 error messages will be displayed. Use this SP to make the necessary adjustments. B047/B048 4-6 SM