Samsung GX10 User Manual (ENGLISH) - Page 208

Setting the Exposure 3. Press the shutter release button halfway. - Focus indicator ( ) appears in the viewfinder when focused. 4. Press the shutter release button fully. - Three consecutive pictures will be taken, the first with no compensation, the second with negative compensation, and the third with positive compensation. (when the number of frames is set to [3]). INFORMATION ƃ When the focus mode is set to SAF (Single mode), the focus is locked in the first frame position and used for subsequent consecutive frames. ƃ The auto bracketing exposure setting will remain effective for twice as long as the exposure metering timer (default setting is 20 seconds) when you release your finger from the shutter release button during auto bracketing, and you can take the next picture at the next compensation value. In this case, auto focusing works for each frame. After about twice as much time as the exposure metering timer (default setting is 20 seconds), the camera returns to settings for taking the first picture. ƃ You can combine Auto Bracket with the built-in flash or external flash (P-TTL auto only) to change only the flash output continuously. However, when using an external flash, holding the shutter release button down to take three continuous frames may cause the second and third frame to be taken before the flash is fully recharged. Always take one frame at a time after confirming that charging is complete. ƃ Auto Bracket is not available when the exposure mode is set to B (Bulb) mode. ƃ Auto Bracket and Multi exposure are not used at the same time. Taking Only Overexposed or Underexposed Pictures You can use Auto Bracket mode for only underexposure or overexposure shots by combining the operation with EV compensation (p.204). Auto Bracket is performed in both cases on the basis of the specified EV compensation value. ŝ207Ş