Samsung GX10 User Manual (ENGLISH) - Page 4

Caution ƈ Leaking, overheating, or burst batteries could result in fire or injury. ҮUse batteries with the correct specification for the camera. ҮDo not short circuit, heat or dispose of battery in fire. ҮDo not insert the batteries with polarities reversed. ƈ Do not fire the flash while it is in contact with hands or objects. Do not touch the flash after using it continuously. It may cause burns. ƈ If you are using the AC power adaptor be careful when moving the camera. After use, always switch off the camera before unplugging the adapter from the wall socket. Then make sure that any connector cords or cables to other devices are disconnected before moving the camera. Failure to do so may damage the cords or cables and cause a fire or electric shock. ƈ Only D-XENON lenses can be used with this camera. Precautions for Battery Usage ƈ Only use specified batteries (SLB-1674) with this camera. Use of other batteries can cause overheating or explosion. ƈ Do not allow metallic or inflammable foreign objects to come into contact with the battery. ƈ Remove the battery when not planning to use the camera for a long period of time. Otherwise the battery may leak corrosive electrolyte and permanently damage the camera's components. ƈ Cover the battery with the battery cap to prevent the short circuit. ƈ Do not disassemble the battery. It may cause leakage or breakage. ƈ If liquid from the battery enters the eyes, wash it away immediately with fresh water and consult a doctor. It may cause loss of eyesight. ƈ If any of the battery leakage should come in contact with skin or clothes,wash the affected areas thoroughly with water. ƈ If there is overheating in, or smoke from, the battery chamber, remove the battery from the camera as soon as possible. When doing so, take care to avoid burns. And then contact your dealer or Samsung Camera Service Centre. ƈ The battery is expendable and its life is shortened through use. If the battery capacity is reduced by half, purchase new one. ƈ After removing the batteries for about 110 hour (4-5 days), the camera may be reset. ŝ3Ş