Yamaha CLP-480 Owner's Manual - Page 79

Message Maximum no. of devices exceeded Memory full Move to?-> Name?-> No device No device (media) No file No response from USB device Notice: Protected Song Overwrite?-> Please wait Protected device (media) Protected Song Remaining space on drive is low Selected drive?-> Set?-> Song error Song too large Start?-> Sure?-> Meaning The number of USB storage devices exceeds the limitation. Up to two USB storage devices can be connected simultaneously. For details, see page 51. Since the capacity and the number of files of MEMORY drive/USB storage device are full, the operation cannot be made. Delete some Songs in the MEMORY drive/USB storage device or move Songs to another USB storage device, and try again. This message prompts you to select the Move destination. Follow the instructions in "Moving files" on page 45. This message prompts you to change the name of the Song/folder which is currently displayed. Follow the instructions in "Renaming files" (page 43) or "Making folders in the USB storage device" (page 45) to change the name, or press the B [- (NO)] button to cancel. A USB storage device was not connected to the instrument when you attempted to perform a device-related operation. Connect the device, and try again. No media is not has been inserted to the selected USB storage device. Insert the media. This message appears when there is no backup file to load in the connected USB storage device. The instrument cannot communicate with the connected USB device. Redo the connection (page 51). If you still see this message, the USB device may be damaged. This message appears when you attempt to handle the Protected Song. For information on the limitation of file operations, see page 41. The file already exists. This message prompts you to overwrite the existing data with new data. Press the B [+ (YES)] button to proceed, or press the B [- (NO)] button to cancel. The instrument is processing the data. Wait until the message disappears, then go on to the next step. This message appears when you attempt a file operation (page 41), record your performance or save the data on a read-only USB storage device. Cancel the read-only setting, if possible, and try again. If you still see this message, the USB storage device is internally protected (such as commercially available music data). You cannot make the file operation or record your performance to such a device. You attempted a file operation to a Protected Song or read-only file. Data of those types have handling limitations (page 41), and also cannot be used for editing (page 37). Use a read-only file after cancelling the read-only setting. Since the remaining space on the MEMORY drive/USB storage device is low, delete any unnecessary files (page 43) before recording. This message prompts you for confirmation to continue the operation with the currently selected USB storage device. Press the Press the B [+ (YES)] button to proceed, or press the B [- (NO)] button to cancel. This message prompts you to save the settings. Press the B [+ (YES)] button to save, or press the [EXIT] button to cancel. This message appears, if a problem is found with the Song data when you select a Song or while the Song is playing. In this case, reselect the Song, and try again to play back. If the message still appears, the Song data may have been damaged. The size of Song data (MIDI/Audio) exceeds the limitation. The following causes can be considered. • The Song size you attempt to play back exceeds the limitation. The limitation for playback is approx. 550KB (MIDI), 80 minutes (Audio). • The Song size exceeds the limitation during recording. The limitation for recording is approx. 550KB (MIDI), 80 minutes (Audio). The recording will end automatically and the recording data before the end is saved. • The Song size exceeds the limitation during converting a MIDI Song to an Audio Song. The limitation is 80 minutes (Audio). This message prompts you to start the operation. Press the B [+ (YES)] button to start, or press the [EXIT] button to cancel. This message prompts you for confirmation of the operation. Press the B [+ (YES)] button to execute, or press the B [- (NO)] button to cancel. Appendix 79 Message List