Brother International PR670E Operation Manual - Page 115

EMBROIDERING SETTINGS Starting/Ending Position Settings ■ Specifying the starting position Touch the key for the desired starting b position setting. The machine can set the start point and the ending point separately from the 9 points of the pattern. Those are upper-left corner, upper-center, upperright corner, center-left, center-center, centerright, lower-left corner, lower-center and lowerright corner. These settings can be used to repeatedly sew a pattern along a diagonal. The starting/ending position settings are specified from the embroidering settings screen.  When a starting position is selected, the ending position is automatically set to the same position.  The embroidery frame moves to the starting position. ■ Specifying the ending position Touch the key for the desired ending c position setting. After selecting the desired settings, touch d . When the embroidery machine is purchased, both the starting position and the ending positions are set to the center of the pattern. 4 Touch . a  The starting/ending position settings screen appears. 1 2 3 1 Specifies the starting position 2 Specifies the ending position Touch a key to select the setting. The highlighted key shows the currently selected setting. Example This key is selected. 3 Touch this key to close this screen.  The embroidering settings screen appears again. Memo • The starting/ending position settings do not change until the key for a new setting is touched. The settings specified before the machine is turned off remain selected the next time that the machine is turned on. 113