Brother International PR670E Operation Manual - Page 44

6. Hooping the Fabric in the Embroidery Frame 1 2 1 Select the simulation speed. Touch , or to change the speed. The speed can even be changed while the simulation is running. 2 Operation keys : Touch to start the simulation at the set speed. : Touch this key while the simulation is running to pause it. Touch simulation. to continue the : Touch this key while the simulation is running or paused to stop it and return to the condition before it was started. • Touch to return to the embroidery frame holder/ embroidery frame selection screen. Touch d screen. to return to the previous After selecting the pattern to be embroidered, check which embroidery frames can be used to sew the pattern. Select the appropriate frame, and hoop the fabric and stabilizer in the embroidery frame. (Refer to "Attaching Iron-On Stabilizer (Backing) to Fabric" on page 84.) For precautions concerning the fabric, refer to page 31. Note • If the fabric is not taut, the pattern may be misaligned or the fabric may pucker. Follow the procedure described below to firmly stretch the fabric in the embroidery frame so that the fabric is not loose. In addition, be sure to work on a level surface when putting the fabric in the embroidery frame. Hooping the fabric in the embroidery frame Select an embroidery frame. a From the sizes of embroidery frames indicated in the screen, select the embroidery frame that you wish to use. Memo • The embroidery can be sewn while the preview image is displayed in the embroidering screen. If the preview image is displayed in any screen other than the embroidering screen, the embroidery cannot be sewn. Embroidery frames that can be used appear lighter ( ) embroidery frames that cannot be used appear darker ( ). Memo • If the embroidery frame holder is not attached to the machine, the embroidering area will not display the correct frame size. (Refer to page 45.) 42