Brother International PR670E Operation Manual - Page 47
Attaching the embroidery frame
![]() |
View all Brother International PR670E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
EMBROIDERING TUTORIAL Attaching the embroidery frame Adjust the width of the embroidery frame holder to the size of the embroidery frame, and then attach the embroidery frame to the machine. As an example, the procedure for attaching the small embroidery frame is described below. Move the left arm to align the screw on the b right side with the mark for the embroidery frame to be installed, and then tighten the thumb screws. For this example, align with mark 4. 2 1 Left arm of embroidery frame holder Move the arm of the embroidery frame holder to the left or right to adjust it to the size of the embroidery frame. 2 Clip on embroidery frame holder. Insert the embroidery frame into the clips on the embroidery frame holder. 3 Positioning pin 4 Holes 5 Positioning slots Loosen the two thumb screws on the a embroidery frame holder. If the screw is too tight, please use the included discshaped screwdriver. 1 Mark for extra-large embroidery frame 2 Mark for large embroidery frame 3 Mark for medium embroidery frame 4 Mark for small embroidery frame 5 Align the screw with the mark. Note • Please firmly tighten the two thumb screws with included disc-shaped screwdriver. If the thumbscrews are not tightened, any of the following problems may occur. • The machine will detect the embroidery frame size incorrectly. • The starting position for the embroidery frame is misaligned. • The embroidery pattern is misaligned. The embroidery frame holder is ready for the embroidery frame to be attached. Hold the embroidery frame level, and then c simultaneously align both the left and right mounts with the embroidery frame holder clips. 1 Left arm 2 Thumb screws The left arm of the embroidery frame holder can be moved. • Only loosen the thumb screws a maximum of 2 turns counterclockwise. Do not remove the screw. • The inner frame should be on top. 45
![](/manual_guide/products/brother-international-pr670e-operation-manual-db31d3a/47.png)